How do I properly install glass door hinges?

The installation of glass door hinges can be a simple process if you follow the right steps. Here is a simple guide.

First, you need the right tools: a screwdriver, a measuring tape, and a spirit level.

• Start by positioning the door. Place the door on two sawhorses or another type of support so that it lies horizontally and you can work easily on the edges.
• Measure from the edge of the door to the desired position of the hinge, usually about 8 cm from the top and bottom of the door. Mark these positions on both sides of the door.
• Now place the hinge at the marked spots and use a pencil to outline the areas where the screws will be attached. Then remove the hinge and drill the necessary holes, paying close attention to the diameter and depth specified in the hinge instructions.
• After drilling, check the alignment of the holes with the spirit level. This ensures correct alignment of the doors once they are installed.
• Reinsert the hinge, insert the screws, and tighten them. Repeat this process for both sides of the door.

Now your glass doors should be securely and properly installed with the new hinges. Remember to regularly check the tightness of the screws to ensure safety.